Vacuum Pressure Controller to control vacuum systems from 8 torr to 800 torr. Cannot be used for high vacuum. Accurate to +/-0.5% of FS and repeatable to +/-0.5% of full scale.
Apex Mass Flow Controller can measure 30 gases. One gas should be specified for the primary gas calibration.
A 115V/60Hz power cable(PVPS24U) is available to power the unit.
The Apex Mass Pressure Controller can be set via the on-board display or via 0-5V, 0-10V or 4-20 mamp signals. For the end user, flows can be read and the controller set via the on-board display. FlowVision Software can be purchased for using a computer to record and graph the flows. The gas selection can also be made from the computer.
For use with a system, a 6 ft. cable(DC-61) or a 25 ft. cable(DC-251) can be purchased in the communication cable section. One end is the 9 pin Din connector to connect to the Apex MFC, while the other end are blank wires.
Calibration Gas - Gas used for factory calibration. There are 30 on-board gases on each pressure controller that can be chosen as the gas measured. The unit is in calibration for any of the gases in the library.
Flow Rate- We may need to know the approximate flow rate into your system since pressure control is somewhat dependant on the size of the vessel.
Output - Output of the pressure controller can be in the form of 0-5V, 0-10V or 4-20 mAmps. Every Apex device has RS-232 capability and does not need to be specified.
Secondary Output - Second output capability. This output can be the mass flow rate, temperature, pressure or volumetric flow rate.
Special Gas Connectors - We can provide a welded VCR female fitting on the gas inlet and output of the meter.
Industrial Connector Option - Controller can be outfitted with a screw on industrial connector for more secure fit on the communications cable. Supplied with a 10 ft. industrial connector cable.
TFT Display - Add TFT Screen for easier reading in low light levels and at times when the screen is viewed at an angle.
- Item #: AX-PC-PR-D-V