Apex Mass Flow Meter for Low Pressure Drop
Click To Enlarge

Apex Mass Flow Meter can measure 98 gases. One gas should be specified for the primary gas calibration. Pressure Drop can be as low as 0.06 PSID. 

 A 115V/60Hz power cable(PVPS24U) is available to power the unit.

The Apex Mass Flow Meter can be set via the on-board display or via 0-5V, 0-10V or 4-20 mamp input signals. For the end user, flows can be read via the on-board display. FlowVision Software can be purchased for using a computer to record and graph the flows. The gas selection can also be made from the computer.

For use with a system, a 6 ft. cable(DC-61) or a 25 ft. cable(DC-251) can be purchased in the communication cable section. One end is the 9 pin Din connector to connect to the Apex MFC, while the other end are blank wires.




Calibration Gas - Gas used for factory calibration. There are 30 on-board gases on each mass flow meter that can be chosen as the gas measured. The unit is in calibration for any of the gases in the library. 

Flow Rate-  Full scale flow rate of the mass flow meter. Turndown ration is 200:1

Output - Output of the mass flow meter can be in the form of 0-5V, 0-10V or 4-20 mAmps. Every Apex device has RS-232 capability and does not need to be specified.

Secondary Output - Second output capability. This output can be the mass flow rate, temperature, pressure or volumetric flow rate.

Special Gas Connectors - We can provide a welded VCR female fitting on the gas inlet and output of the meter.

Industrial Connector Option - Meter can be outfitted with a screw on industrial connector for more secure fit on the communications cable. Supplied with a 10 ft. industrial connector cable.

Totalizer - On-Board display of the total flow from the last tare of the unit.



  • Item #: AX-MW-FR

Apex Mass Flow Meter for Low Pressure Drop

Price: $1,215.00
* Marked fields are required.
Qty: *